Payment & Shipping Terms:
|Material:||SS304||Heat Exchange Area:||0.101m²|
|Sectional Area:||0.00072m²||Angle Diameter:||45|
|Capacity:||35||Heat Exchange Area:||3-10m²|
|Pressure:||2Mpa||Working Temperature:||Depending On The Gasket Material|
grain mill homebrew,
PHE0.1B Plate Heat Exchanger Auxiliary Brewing Equipments 3-10m² Heat Exchange Area
The plate heat exchanger consists of a frame, which consists of a head, follower, column, carrying bar, guiding bar, and a number of clamping bolts. In between head and follower a varying number of pressed plates are clamped together. Each plate is supplied with a gasket, so that the plates form a closed system of parallel flow channels, through which the medias flow alternatively at every second interval.
The Plate Stack - Media
The gaskets are glued on the plates, securing tightness between medias and the atmosphere. Between the different medias there are double gaskets, which have intermediate drain areas, meaning that mixing of the two medias is impossible. Every second plate in the stack has to turn 180°, so that the plates form a closed system of parallel flow channels, through which the medias flow alternatively at every second interval.
The first plate after the head and intermediate frames is mounted with a gasket in all the gasket grooves.These gaskets are cut out of ordinary gaskets.
Glue Less or Glued Gaskets
Some plate heat exchangers are delivered with glue less "Sonder Snap" gaskets. In these units it is possible to change the gaskets without using glue. However, the gasket on the first plate after the head and intermediate frame should be glued on in the pattern displayed above.
The plates and plate patterns are constructed to obtain a high thermal efficiency with a low pressure drop
There are two pattern designs available with different pressing angles giving respectively high/low turbulence flow, dependant on the given selection
The inlet channels allow for maximum strength in the inlet area, whilst maintaining minimum of contact points, reducing blockage at the flow distribution zone
The inlet design ensures even distribution of the liquids across the heating surface
The gasket is placed in a dedicated retaining gasket groove. This secures the elasticity of the gasket even after a long time of compression
The plate heat exchangers can be widely used for heating, petroleum, chemical, food, paper, pharmaceuticals, machinery, metallurgy and other different areas.
|heat exchange area(m²)||0.0618||0.0966||0.101||0.204||0.222||0.318||0.547||0.86||1.055|
|tray spacing (mm)||3.8||3.8||4||4||3.8||3.8||0.547||3.8||3.8|
|angle diameter (mm)||38||60||45||70||75||80||135||200||200|
|heat exchange area( m²)||1-5||3-10||3-10||4-25||5-30||8-40||25-120||50-180||80-250|
|working temperature||Depending on the gasket material|
Contact us immediately to get latest specification and price of PHE0.1B Plate Heat Exchanger Auxiliary Brewing Equipments 3-10m² Heat Exchange Area
Contact Person: Cindy Chen
Tel: 0086-137 9040 7437