Payment & Shipping Terms:
|Material:||Stainless Steel 304 / 316L||Heating:||Electric/Steam/Gas Fired|
|Thickness:||3mm For Interior Shell/2mm For Exterior Shell||Type:||Vertical / Horizontal Type|
|Capacity:||500L||Certification:||CE, ISO, TUV, SGS|
CE, ISO, TUV, SGS Approved Vertical / Horizontal Type Bright Beer Tank
·Butterfly valves, sample valve, PRV
·Clamps and gaskets, pressure gauge
·Stainless steel legs with stainless leveling footpads
·Interior shell:304 stainless steel, thickness 3mm
·Exterior shell:304 stainless steel, thickness 2mm
·Interior and exterior finish polished to mirror finish
·Fully welded exterior shell
·dished cone bottom, with an average of 10% headspace
·Side manway door, shadowless
·80mm Polyurethane insulation
·CIP arm and spray ball
·Sanitary tri-clamp connection
1) UL & CE Rated Controls and Components.
2) Tanks conform to all ASME pressure vessel ratings and standards.
3) 100% Pressure & leak testing of all tanks, jackets, and hard piping. All electronics and brewhouses pre-assembled and tested before shipping.
4) All brewhouse piping is stainless hard piping. No plastic piping used in the brewhouse for wort or beer.
5) All control panels are pre-wired and pre-tested.
6)PLC Siemens color touch screens control system.
7)Complete mechanical engineering support, on-site installation, start-up and training support for all systems.
SPECIFICATIONS FOR 2000L BRITE TANK
Dual-zone dimple cooling jackets (3 or more on larger tanks);
Interior shell: 304 stainless steel, thickness 3mm /11 gauge;
Cooling jacket: 304 stainless steel, thickness 2mm /14 gauge;
Exterior shell: 304 stainless steel, thickness 2mm /14 gauge;
80mm Polyurethane insulation;
Interior surface to finish pickled and passivated;
Exterior surface to brushed, #4 finish;
Top manway, shadowless;
Dry hop inlet at the top.
Sample Valve x1;
Pressure relief/vacuum valve x1;
Temp. sensor / thermometer x1;
Rotating racking arm with butterfly valve x1;
Bottom outlet with butterfly valve x1;
Spraying Ball with down tube x1;
Stainless pipe legs with adjustable footpads x4;
Design pressure 45 psi (3bar); working pressure 15psi (1bar)
4 stainless steel legs with leveling footpads
Interior shell: 304 stainless steel, thickness 3mm
Exterior shell: 304 stainless steel, thickness 2mm
Interior and exterior finish bright polish to 0.6~0.8 μm, hygiene surface
All Interior welds ground to a smooth0.6~0.8 μm sanitary finish
Flanged and dished head top and bottom
20% headspace unless a different volume is requested
Combined drain extensions and beer port are standard
Top manway or side manway door
Dual-zone in the sidewall and bottom dimple cooling jacket with glycol inlet and outlet
Polyurethane insulation thickness 80mm for the cooling jacket on side and bottom
No welding CIP arm and rotating 360-degree reach spray ball
Carbonation system with micron stone
Solenoid valve, pressure relief valve (safe valve) are standard.
Temperature sensor well
All clamps and gaskets to attach all accessories
Tank complete with piping, fittings, sanitary valves and all parts.
If you are would like to change, add, remove or modify any part of the tanks, we can accommodate that. Specific fitting sizes, changes and locations will be set during the design process after a deposit is taken.
Contact Person: Nancy Wang